This Digital I/O (Data Aquisition) card was removed from a test fixture (rack mount PC) and appears to be in good condition.
You will recieve card in static bag. No cables are included.
Documentation and drivers are available on
manufacturers web page.Manufacturer: Contec
Model Number: Pio-16/16tb(pc)
Version: 9841A
Below is information on this card gathered from the manufactueres web page http://www.contec.com
We revised some phrasing to allow it to be more readable. (original translation was poor)
This card is a is an ISA based IO card capable of 32 TTL inputs or outputs. (16 inputs and 16 outputs)
All inputs/outputs are opto isolated and capable of high current (250ma max)
Opto Isolated I/O allows for lower noise on signals as well as better protection.
The Opto-isolated drivers can be driven from internal or external power supply (5Volt)
The 16 channels of I/O can be divided into two groups of 8 for easier signal managment
Various channels can be set for interrupt modes
Here is a list of features in detail:Input type: TTL level input by Opto-Isolated (Negative Logic)
Input resistance: 1.1kohm
Input ON current: More than 2.5mA
Input OFF current: Less than 0.73mA
Inputs channels: 16ch (2ch is available at interrupt input signal) (16ch with 1common)
Interrupts: (a maximum of simultaneous 2ch) Falling-Edge(HIGH->LOW)
Output type: TTL driver output by Opto-isolated (Negative Logic)
The maximum output rated voltage: DC+5V
Output rated current: 6.4mA Max.
Output channels: 16ch (16ch with 1common)
Response time: Less than 1usec
Signal length (max): about 5m(Dependent on wiring environment)
External circuit power supply DC+5V (+-10%)
Internal power DC+5V 250mA Max.
I/O Address 8 bits x2 port occupancy (Input/Output to Common)
Conector type: DC-37P-N (male)[JAE] 37pin
Software can be written in DOS (GW-Basic), ActiveX, DDE Com, LabVIEW
Documentation and drivers are available on
manufacturers web page.We do not have the equipment to test this board and it is sold as is
Shipping weight is 1 lb
