44-Yellow LED Programmable BarItem Description, Features, and SpecificationsThis is a 8 pack of LED bars that have 44 yellow LED's per bar.
Each LED is addressable in each bar.
We are selling these in 8 pack which is optimal for building an LED readerboard (typical 7 high is for characters and 8 is great for graphics)
Also 8 pack will survive shipping better.
It is based on the STP08CL596 chip made by ST.
There are six IC's. Five control forty LED's(eight each...) and one IC controls a group of four.
Serial data goes into the first chip's SDI pin then it outputs serial data to the next chip.
Each LED bar comes with a matching female plug with wires attached.
The female plug is manufactured by JST, part number 06ZR-8M and are available on the internet.
Overall length including the male connector at the end is 31 inches.
The units run from 5v DC.
Each LED draws 20mA.
If all the LEDs are turned on at the same time that is a total of 880mA.
Be sure you figure this in when selecting your power supply.
Pin out:
J1 Connector Pin Out (Pin 6 is on the end of the bar)
1: SDI (to the first chip)
2: CLK (to all chips)
3: /LE (to all chips)
4: /OE (to all chips)
5: Ground (to all chips)
6: 5vDC (to all chips)
LED Bar Code For Arduino vs1LED Bar Code For Arduino vs2 (Jerry)
LED Bar Code For Arduino vs 3 (Michael)
Due to the length of the LED bar we are shipping these as an 8 pack.
If we shipped them as single units they might not survive.
We do have them available in single packs at our retail store.
Dimensions for shipping is aprox 33 x 5 x 5 so it will trigger extra fees with usps. (ugggh)
If you need a bunch give us a call or email and we can work out shipping arrangements.
Item Condition:New old stock...very bright yellow!
You will Receive:(1) 44-Yellow LED Programmable Bar with matching connector
Item Weight:Item weight is approximately 0.22 pounds.
